USB Programming Cable USB to DB25 Male RS232 Serial Cable for PLC-5 Controllers USB-1784-CP10

USB-to-VGA AdaptersUSB Programming Cable USB to DB25 Male RS232 Serial Cable for PLC-5 Controllers USB-1784-CP10Material: PVC outer jacketCable: 26AWG*3C, OD4.0Color: BlackCable Length: 3.0M in stock, other length can be Connector A: USB 2.0 type A maleConnector B: DB25 maleChipset: FT231XSLevel: USB to Serial RS232Application: USB programming cable for PLC-5 Controllers USB-1784-CP10About FT231FT231X Full Speed USB to Full Handshake UARTKey Hardware FeaturesThis USB2.0 Full Speed IC offers a compact bridge to full handshake UART interfaces. The device is a UART, capable of operating up to 3MBaud, with low power consumption (8mA). The FT231X includes the complete FT-X series feature set and enables USB to be added into a system design quickly and easily over a UART interface.Single chip USB to asynchronous serial data transfer interface.Entire USB protocol handled on the chip. No USB specific firmware programming required.Fully integrated 2048 byte EEPROM for storing device descriptors and CBUS I/O configuration.Fully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGA.Data transfer rates from 300 baud to 3 Mbaud.512 byte receive buffer and 512 byte transmit buffer utilizing buffer smoothing technology to allow for high data throughput.'s royalty-free Virtual Com Port (VCP) and Direct (D2XX) drivers eliminate the requirement for USB driver development in most cases.Configurable CBUS I/O pins.Transmit and receive LED drive signals.UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity and asynchronous bit bang interface options with RD# and WR# strobes.Battery Charger Detection. May be used by mobile devices to detect the presence of a charger on the USB port to enable higher current / faster charging of batteries.Device supplied pre-programmed with unique USB serial number.Supports bus powered, self powered and high-power bus powered USB configurations.Integrated +3.3V level converter for USB I/O.True 3.3V CMOS drive output and TTL input.(operates down to 1V8 with external pull ups and is also 5V tolerant)Configurable I/O pin output drive strength.Integrated power-on-reset circuit.UART signal inversion option.Internal 3.3V/1.8V LDO regulatorsLow operating current of 8mA (typical) and USB suspend current of 125uA (typical) current.Low USB bandwidth consumption.UHCI/OHCI/EHCI host controller compatible.USB 2.0 Full Speed compatible.Extended operating temperature range: -40°C to 85°CAvailable in compact Pb-free 20 Pin SSOP and QFN packages (both compliant).Typical ApplicationsUSB to RS232/RS422/RS485 ConvertersUpgrading Legacy Peripherals to USBCellular and Cordless Phone USB data transfer cables and interfacesInterfacing MCU/PLD/FPGA based designs to USBUSB Audio and Low Bandwidth Video data transferPDA to USB data transferUSB Smart Card ReadersUSB InstrumentationUSB Industrial ControlUSB MP3 Player InterfaceUSB FLASH Card Reader and WritersSet Top Box PC USB interfaceUSB Digital Camera InterfaceUSB Hardware ModemsUSB Wireless ModemsUSB Bar Code ReadersDedicated Charger Port (DCP) detection enabling battery charging at higher current for faster charge times.==========High-concerned chemical : NonePackage : YesModel Number : USB-1784-CP10Type : Serial CableOrigin : Mainland Certification : ,ULColor : BlackCable Length : 3.0MConnector A : USB 2.0 Type A MaleConnector B : DB25 MaleChipset : FT231XS

• USB-to-VGA Adapters
• USB Programming Cable USB to DB25 Male RS232 Serial Cable for PLC-5 Controllers USB-1784-CP10