Garage Door Torsion Spring Single LW .234 x 2" ID x 30" - with Winding Bars (Center Steel Bearing)

Garage Door Torsion Spring with option to purchase Winding Bars Springs are made in the USA using Oil Tempered, USA made Wire - this makes for a spring that is durable and will outlast imported springs. Winding and Stationary cones are included and are Pre-installed (Cones are Imported) First of all it is very important to have the correct spring for your door, if the spring is not matched correctly to the door, it will not work properly and can be dangerous or damage your operator. Step 1 is to determine the spring inside diameter, if the spring is broken you can simply use a ruler to measure the inside of the broken end, if the spring is still in one piece you can measure the outside and deduct the wire size X 2. You also may be able to find stampings on the cones which will help determine the ID, ( P200 or P2000 for 2” and P175 for 1 ?”) The most common sizes in residential springs are 1 3/4" and 2" ( Raynor doors use 2 ?” ID ) Step 2 is to measure the length of the spring, Measure the spring only, not including the winding and stationary cone. If the spring is broken measure each piece and add the two measurements together to get the total length. If the spring is still in one piece and wound, it will be longer by 2-3” then when it is relaxed.. the proper way to measure is to unwind the spring to measure the correct length Step 3 is only important if ordering a single spring, determine the wind direction of the spring, right hand wind ( RW) or left hand wind (LW). This is probably the most confusing part of the spring ordering process, as The RW is normally on the Left side and the LW is normally on the Right side. Be sure to check the wind direction and not make assumptions. If you look at the end of the spring and compare to the picture, you will be able to determine the correct wind direction.

• Includes 1 Left Wound Spring, Wire size is .234, Inside Diameter is 2", length is 30" - With Winding Bars (Center Steel Bearing)
• Winding and Stationary cones are included and are Pre-installed (Cones are Imported)
• Springs are made in the USA using Oil Tempered, USA made Wire - this makes for a spring that is durable and will outlast imported springs.
• First of all it is very important to have the correct spring for your door, if the spring is not matched correctly to the door, it will not work properly and can be dangerous or damage your operator.