Flat Center Caps for Torq Thrust Wheels, 1-Pair, Low Profile, Natural Aluminum, 2-1/4" Spacing, American Racing Post-1980, Trans-Am Style

This is a pair of two flat aluminum center cap delete plates for NEW-STYLE American Racing Torq Thrust wheels. They measure appx. 3/32" thick (thinner than other caps on the market) so they're extremely lightweight and they'll give your wheels a nice deep-dish look! These fit wheels with 2-1/4" spacing between the center cap screw holes found in the newer-style (post-1980) Torq Thrust D's, II's, and Originals. They do not fit wheels with 2-1/8" spacing between the screw holes including pre-1980 Torq Thrusts, US Mags, E-T Classic V, and V-40/V-45 (see my other listings for those). Please measure to verify that you need 2-1/4" spacing. Included with each pair are 10 stainless steel (18-8) button head allen screws. These caps come unfinished in natural aluminum so you can expect minor scratches, blemishes, and/or uneven color (Note: they are deburred). This is a great option for those wishing to apply their own custom finish (e.g. polished, anodized, painted, brushed) or perhaps a pristine finish is not necessary. TIP: Scotch Brite sanding pads clean these up in seconds! The sides do have a slightly granular texture which is barely noticeable since the caps are so low profile. Made in the USA! If your front wheels require clearance for hubs/dust caps, please check my other auctions for a set with either 1-7/8" or 2-1/4" diameter holes in the middle to clear Wilwood hubs. If you're interested in center caps for older-style Torq Thrust wheels, please see my other listings.

• One pair of flat center caps for Torq Thrust Wheels which fit American Racing post-1980 Torq Thrust D’s, II’s, and Originals. Made 100% in the USA!
• Low profile (only 3/32” thick) gives your wheels a custom deep-dish and trans-am style race car look
• Natural unfinished aluminum will have minor blemishes and/or uneven color (Note: they are deburred). Great option for those wishing to apply their own custom finish (e.g. polished, anodized, painted, brushed) or perhaps a pristine finish is not necessary. TIP: Scotch Brite sanding pads or a DA sander clean these up in seconds!
• 2-1/4" spacing between screw holes – Please measure to ensure you don’t have 2-1/8” spacing which is a separate (but similar) style center cap