Coolant Pressure Tester kit 14 Pieces of Water Tank Pressure Leak Detection Leak Tester Kit Antifreeze Coolant Vacuum Filling Pressure Changer Tool Plastic Vacuum Type Cooling System Kit

Cooling System Pressure Test Instructions for use 6. Check the pressure gauge. 6.1 Assuming that the pointer of the pressure gauge remains unchanged for several minutes, it means that the system can be used normally 6.2 If the pointer drops, it indicates that the system has cracks due to pressure damage 6.2.1 Check whether there is water leakage in each pipeline of the water tank, and repair it according to the location of the water leakage. 6.2.2 Check the condition of the rubber ring. 6.2.3 Re-test to ensure that the repaired system can be used normally. 7. After the test is completed, release the pressure from the pressure relief valve to the pressure gauge to zero. 8. Before finishing using the collection: 8.1 Insert the water tank probe into the quick head, pressurize several times, and leave the residue in the pipe of the hand pump group The water vapor can be discharged, and it can be stored. 8.2 Pour pneumatic oil into the air inlet at the rear of the hand pump group to lubricate the piston in the pipe. Then Insert the water tank probe into the quick, pressurize several times, and drain the residual steam oil in the pipe of the hand-pressure pump group You can save it when you leave it. Safety warnings and precautions This product is only used for water tank pressure leak detection, please do not move it for other purposes. Warning! When using the product, please strictly abide by the relevant authorities and general factory regulations to ensure Health and safety. Warning! Before opening the water tank cover, make sure that the water tank is in a cold state. To keep the product in the best and safe state, it must be kept in good condition and clean. If the product Do not use if there is any damage. When using the product, please do not wear watches, jewelry or loose clothing. Operate the leak detection group and the vehicle in a well-ventilated condition to avoid inh

• 1. Open the water tank. Before opening the water tank cover, make sure that the water tank is in a cold state.
• 2. Choose the water tank probe of the appropriate car series.
• 3. Tighten it to the water tank while inspecting the rubber ring to be completely consistent.
• 4. Insert the quick connector into the water tank probe.
• 5. Take out the hand pump set, pressurize to the pressure, indicating that the indication reaches approximately 15~20psi (or 1Bar)