2 Piece 10' White Anchor Pin with Screw Connector and Lanyard System

Included: 10' total length 2 piece Stick It Anchor Pin (1 x 3' anchor pin with a T-handle and male screw connector and 1 x 7' anchor pin with a female screw connector on one end and grounded point on the other end) 1 each 84” and 24" braided 3/8" floating lanyard 2 x Mounting clips, screws and Velcro safety straps When you need the strength of a one-piece anchor pin, but want to use it in deeper water, this system is for you. This system is used when a customer requires a 10 foot Stick It Anchor Pin that can be unassembled for easy storage. Stick It Anchor Pins are for use in shallow water and are recommended for flats boats up to 24 feet or bay boats up to 19 feet. If you are fishing flats, shallow channels, sand bars, points and mangrove shorelines in 8 feet of water or less you can be assured of faster, quieter and stronger anchoring. The Stick It Anchor Pin 24" and 84" floating lanyard set are strong braided 3/8” dock lines with a 6’ loop on one end and a 1.5” loop on the other end of each lanyard. The smaller loop is for placing your anchor pin through. The larger loop is for attaching to your vessel on an anchor cleat, a trailer tie down cleat or a cross bar in a canoe. The idea is to have your lanyard attached to your vessel before anchoring. Use the mounting clip set to easily store your Anchor Pin on your vessel. Install mounting clips about 1.5’ in from each end of your Stick It Anchor Pin. The stainless steel screws need to be seated to the base of the mounting clips so that the head of the screw sits down inside the body of the mounting clip. Our velcro rough water safety straps can be used for added security when storing your Stick It Anchor Pin on your vessel using our mounting clip set. Designed to be installed under mounting clips, fuzzy side down. The 10’ 2 piece Stick It Anchor Pins are not to be used with any of our bracket systems due to the leverage factor that is involved.